About
All feedback (61)
- watfas (7587)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (1)
May 25, 2017
BE CAREFUL INSTALLING
22 of 22 found this helpful These boards burn out often because of a bad DC motor in the freezer. The motor is only a $25 part and should be replaced at the same time as the control board if there is any indication that complete or partial motor failure is what caused the control board problem. Otherwise like me you will immediately fry the new control board you just installed. So how can you tell if failure of the DC motor in the freezer is what caused your control board failure? One way to know is if your freezer has been malfunctioning. If it's not getting cold enough to make ice, or keeping cold, or you don't here and feel the noise and air flow in the freezer. Another way to tell which is very definitive is to look at the two resistors on the control board. SEE PICTURES. If the upper one is burned out, your DC motor is failing and needs to be replaced at the same time you change out the board. Just sharing so others learn from my expensive lesson after frying the first replacement board I bought here. The resistor overloaded and burned out within just a few minutes.