About
All feedback (506)
- w***u (721)- Feedback left by buyer.More than a year agoVerified purchasegreat seller communication fast ship AAA+++
- tomautoparts (218718)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- cyclisticblue (2371)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- mg000000 (25270)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- animalhouse2010 (47245)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- *****- Feedback left by buyer.Past monthVerified purchaseA+++
Reviews (1)
Oct 11, 2016
Needs improvement
1 of 1 found this helpful The bowl gasket is a good fit, as is the needle and seat assemblies. However, the idle mixture screw springs are too long, so that when fully compressed, do not allow the mixture screw tip to fully seat in the passage, causing the initial screw setting spec to be off about 3/4 of a turn. In other words, when the screw is bottomed out, then backed out the specified amount of turns, you will have a richer than expected mixture at idle. The other issue I have is that the brass seat assembly is not supplied with an inlet screen, like the O.E. seat.