About
All feedback (202)
- thepartresource (21062)- Feedback left by buyer.Past 6 monthsVerified purchaseExcellent buyer, a pleasure to do business with you!
- motorsportgaskets (7884)- Feedback left by buyer.Past 6 monthsVerified purchaseA ++++ Hope to deal with you again. Thank you.
- mecautocarkeys (1450)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- cascadeclear (6814)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- fbjr186 (1554)- Feedback left by buyer.Past 6 monthsVerified purchaseFast payment great buyer thank you for your business
- keytoolplus (859)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (5)

May 31, 2021
Check your application,pass if using on a J engine
So, the DS2-1 is shown to be usable for the KZ1100 s. However, the unit is limited to applications using ignition coils that have a resistance of at least 3 ohms, stock KZ1100 coils are factory rated at 2.8-1.8 ohms which means if installed without changing your STOCK coils the unit will fry. I would recommend using 2 gm hei 4 pin modules with the stock pickup coils and ignition coils( this will allow you to use higher draw coils if you wish) to replace the failed stock ignitor. I have not installed the unit but am saving it to use on a Z1 that I will restore next winter. The draw back to this unit is its limitation as to coil power, if you are looking to upgrade to a hotter spark than the old Z1, this is not your ticket. Quality is yet to be determined as it has not been installed as yet.

Jul 18, 2017
Good source for jets.
Seem identical to the oems, hope they are flow checked, and I like the price. Good on the shipping.

Dec 06, 2018
Good buy, good switch.
Seems to be exact same switch that was used in the saw by Mfg. Price is a fraction of other suppliers, Porter Cable does not supply this switch any longer and I am glad that I can still use my saws-- only problem was the switch contacts were burned up.