About
All feedback (58)
- blueknifecomputer (16789)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- helidirectrc (57541)- Feedback left by buyer.Past 6 monthsVerified purchaseVery pleasant and courteous buyer, great to deal with, Thanks!
- discount.rc.parts (8575)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for shopping at Discount RC Parts. Enjoy your purchase!
- rcoptioncompany (13384)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- zvigor (1884)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- justdobest (2416)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
Reviews (1)
Jan 13, 2022
Very nice brass spinner!!!
Purchased this after reading the warning message. This is a very nice brass spinner. Craftsmanship is top notch. Spin times are between 2:45 and 3:20 which is pretty good for a brass spinner. This spinner also has a good weight to it. When I first received my spinner and spun it for the first few times, I noticed an obvious wobble in the main ring. Well, the challenge to this spinner is being able to balance it out. This is a very easy process and is normal for this style of fidget/ tinker spinner. It's a puzzle and fidget toy all in one. To balance the spinner, before loosening anything, hold the spinner between your thumb and index finger; give the spinner a very slight spin, spinning it only for a few seconds. The spinner must be in the vertical position while holding and slightly spinning it. When the wheel stops, if it is off balanced/ wobbles, the weighted section will fall towards the ground (gravity.) This means that the center hub needs to be moved slightly in the opposite direction. Grab the top pin, and lay the spinner flat, loosen only three (3) off them opposite of the weighted side and move the center hub. Tighten everything and check. Repeat this process if necessary. It took me less than two minutes to balance my spinner. Please note, if all spokes are loosened together, the center hub will fall free. To reassemble, align the spokes with the grooves cut into the hub and begin the balancing process. This spinner looks very cool when properly balanced and spun! The spinner is relatively quiet during high-speed spins. I would definitely recommend both the spinner itself and the Vendor, LT Recycling! This spinner is not for small children, as it contains small parts.