About
All feedback (114)
- b***b (1196)- Feedback left by buyer.More than a year agoVerified purchaseLooks good. Packaged well.
- goodbuy0808-6 (942)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- venetian44 (1329)- Feedback left by buyer.More than a year agoVerified purchaseYour item will be mailed on Tuesday, January 2, 2024. There's no mail service on Monday, January 1st. Thank you for your purchase.
- sweetth-2828 (706)- Feedback left by buyer.More than a year agoVerified purchaseVery well. Paid quickly.
- *****- Feedback left by buyer.More than a year agoVerified purchaseThank You For Your Purchase!! A+++++++++++
- carnivorefarmer (134)- Feedback left by buyer.More than a year agoVerified purchaseEasy transition. A+++
Reviews (5)
Apr 04, 2017
Flimsy plastic
1 of 1 found this helpful This is a flimsy plastic thermo-formed part. It does not fit a 2016 touring with stage 2 very well, even when removing the rubber support insert. Shakes and looks like crap. Expected better due to the price and name.
Aug 26, 2020
If it sounds too cheap......
1 of 1 found this helpful Late model Harley Bagger with 130mm wide tire.
Tire gets lodged in the front "V" upright and makes it very difficult to get out.
Front upright has only one bolt and it holds the upright up off of the base, like a pivot point. The horizontal pin and hole clearance for the front upright does nothing and the front end can lean left or right untill the corners of the bracket bottom out from pivoting. Too much for comfort with a $30k motorcycle. The hole should be higher in the bracket so it is fully supported by the base and the goofy side slots and pin setup need to be re-thought.
The rear pivoting bracket also catches the rubber and grabs it in place like a side clamp. It is difficult to get into and the feet won't hold it in place. You will need to anchor this. I had to jack the whole bike up and pound this off the tire with a dead-blow mallet.
I had high hopes and tried various arrangements (since there were no instructions other than where the bolts go) but I had zero success.
Apr 04, 2017
Chromed metal. Heavy.
The screw portion is a set screw that is Loctite-ed in place. You can use 2 nuts to lock up and remove the set screw and replace with a longer one if you need more length like I did. Components are metal and chrome appears to be good quality.