About
All feedback (1,034)
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- mark-down-merchant (7148)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- partshawk (109779)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- tomautoparts (184019)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- lfdsllc (43499)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- pro-safety2009 (116884)- Feedback left by buyer.Past 6 monthsVerified purchaseValued customer, highly recommended! Thanks for shopping with pro-safety2009!
Reviews (3)

Dec 05, 2024
Totally satisfied with the item and ever...
Totally satisfied with the item and every aspect of the purchase. They perform well so far. The tractor turns nicely, and as a bonus, my old Massey Ferguson now has a fancy European look due to the tread pattern.

Jun 18, 2019
Does not even begin to fit; A total waste of money.
Does not even begin to fit the listed application. With the raised boss in the hole, neither bolt hole will line up. I thought at least I could flip it over and use it temporarily, but the bolt holes aren't even spaced properly from each other! Every possible dimension is incorrect.
I was foolish for waiting several months to finally (attempt to) install this, because too much time has passed, and the seller won't even respond to messages since the chance of negative feedback has long ago expired.

Apr 27, 2016
Works perfectly for the application it's intended for.
2 of 2 found this helpful Occasionally, you encounter a carburetor problem that even the most determined cleaning won't fix. I solved one such problem with this carb. The engine now starts and runs like brand new.
As others may have mentioned, you must notice if you have a "low" or "high" vent type. The high vent type has the third hole at the 2 o'clock position in addition to the screw holes on the filter side of the carburetor. If you have a LOW vent type like I did, you will need to buy (ideally, or you can make) a gasket with this extra hole. You will also have to drill a hole in your filter housing to match. Everything else matched up perfectly.