About
All feedback (42)
- carpartswholesale (3371596)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++
- maverickparts (4430)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- e-herko (197071)- Feedback left by buyer.Past 6 monthsVerified purchaseA+ Buyer, Will do business with again
- detroitaxle (1048185)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- soylin_autoparts (1013)- Feedback left by buyer.Past yearVerified purchaseHope to deal with you again. Thank you.
Reviews (3)

Dec 18, 2024
I have only installed: sway bar end link...
I have only installed: sway bar end links, tie rods inner snd outer, idler arm and idler arm support. All parts matched the fit and finish of the OEM parts and bolted in without issue. I have driven 100+ miles without issue. However, the castle nuts could either be taller or the pin hole on the thread shaft of thr parts lower because it seemed I had to barely tighten the castle nits otherwise the pin would be ABOVE the teeth of the castle nut and not BETWEEN them.

Dec 18, 2024
Install required removal of door card bu...
Install required removal of door card but otherwise the install took an hour for the two (had to figure out the door card needed to be removed). Unsure if the heat aspect works yet as it hasn't gotten ice/snow on them enough to tell. The passenger side mirror shakes more than i would like from thr wind but the housing is rock solid. The driver Mirror shakes less but still slightly does. They do not make noise from the shaking. Unsure if all are like this.

Dec 18, 2024
I have not started the car to see if a n...
I have not started the car to see if a new code has been thrown for this sensor being installed over the OEM one. This cable is about 3x longer than the OEM one which connects right in front of the front transmission pan. I had to hippie the excess to itself and then to the support brace under the subframe. The connector fit and locked onto the OEM male plug without issue and tightened as well.