tubes70 on eBay

About

Location: United StatesMember since: Apr 29, 2002

Feedback ratings

Last 12 months

Positive0- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (1,357)

cheeks519 (1684)- Feedback left by buyer.
More than a year ago
Verified purchase
A+ quick payment
XLhWVOlxQ4W@Deleted- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
9i-toys (1371)- Feedback left by buyer.
More than a year ago
Verified purchase
Very good buyer, happy communication, hope your next purchase
redmushroom-usland (5179)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
replicaweaponry (52359)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
jeffpesos313 (5655)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

See all feedback

Reviews (12)

Kel-Tec 9mm Magazine PF-9-498 Luger 7 Round Clip NEW in Package

Feb 23, 2017

9 mm mag

Works fine in Kel-tec.

Fuel Pump For Kubota BX2360 BX23 BX23D BX24 BX24D BX22 BX25 BX2660 BX2660D

Jul 09, 2019

Kabota fuel pump and filters.

Seems to work well, time will tell about durability. Did not retain the original locations for the pump and prefilter, too hard to get to up under the centerline of the BX 2660. Moved both to the outer left side of and under the footrest area of my Kabota. Did not even have to drill, used pre-existing holes.

ATI Mosin Nagant Stainless Bolt Handle Kit MOI0700

Aug 03, 2016

ATI bolt handle installation

Length, angle, and positioning are excellent the dawback that I see is installation. A drillpress vice and drill press are necessary! I do not recommend that someone with limited machining skills attempt to install this with the tapping of blind holes involved break a tap off and you are in deep "do-do". This is the 4th or 5th one I've installed and on some bolts it is necessary to use a dremel to cut or reduce the original bolt handle diameter at it's base. One bolt required cutting the area that the ATI bolt handle rests on until it was flat enough to allow it to set on the bolt solidly. Finally rough the mating surfaces slightly and do the final installation with JB Weld. It will also benefit you to obtain and use a bottoming tap.

2 of 2 found this helpful

See all reviews