About
All feedback (1,174)
- *****- Feedback left by buyer.More than a year agoVerified purchaseNever sent order. Dragged on for weeks with excuses and canceled order.
- 6***2 (1231)- Feedback left by buyer.More than a year agoVerified purchaseVery good communication! Easy to deal with, thanks for the purchase!
- uniquefindsja (2382)- Feedback left by buyer.More than a year agoVerified purchaseThank you! Fast pay! Great dealing with��
- best-supplies (43513)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- wolfcreeksawshop (20328)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer at wolfcreeksawshop!
- theropshop (329514)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (5)
May 14, 2016
Whiteside flush trim bits
Best I can find I go through a lot of router bits I have tried other less expensive bits and they have come appart or cut poorly. I use this particular bit to trim off the long ends of box joints end grain and as a pattern bit and cut through 3/4 inch pine in one pass not trim off the excess but actually cut through it most people would call this abuse but they hold up good I also trim off hardwood overhang exotic hardwood paduk (IPE extremely hard) cherry rock maple oak ,walnut, rosewood and others . I use there round over bits to go over 1/4 box joints no tear out never had a bearing failure. I believe they are the best money can buy. I use and abuse them with no issues. I here people say that cheaper bits are ok if you only use them once in a while but if you use it 4 or 5 times and its dull or breaks and you buy another it's costing you more . You should just buy a Whiteside and it will probably last you a lifetime. I have used other supposed quality bits costing as much or more and had bearing failures. Never have had a Whiteside bearing even wear out rather on come apart . I just tried a less expensive bit and it cost me dearly ruined my project and cost me a hundred times what I saved. American made Whiteside bits only from now on . I even save my used dulled bits and use them strictly for plywood . I cut out holes for speakers I screw a old speaker to plywood drill a hole and let the bearing ride on the metal speaker basket and cut the hole I would say that's abuse and have never lost a bearing even pushing very hard with a dulled bit . You can absolutely trust these bits
Mar 29, 2011
CHAMPION 600
2 of 2 found this helpful GREAT VINTAGE LOOKING AMP FINE AS IS BUT LOTS OF FUN TO UPGRADE SWITCH TUBES TRY DIFFERENT SPEAKERS MODIFY CIRCUIT BOARD OR DO LIKE I DID AND TEAR OUT THE GUTS AND START FROM SCRATCH LOTS OF SOUND IN A SMALL PACKAGE LOVE THEM
Dec 10, 2018
Quality leather handles
I build cabinets for a living and just found these handles I have tried them all from fender original to custom made and these are better than fender and just a tad less than the custom at a fraction of the cost my new go to handles highly recommended