About
All feedback (248)
- uk_outboards (31674)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- jomashop (187291)- Feedback left by buyer.Past yearVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- 8ten1944 (252175)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- ajrsjb2798 (9396)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- rcry4301 (2192)- Feedback left by buyer.More than a year agoVerified purchaseThank you
- qualityboatsalvage818 (33285)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (3)
Jul 20, 2019
Nice upgrade!!
1 of 1 found this helpful I had the switchbacks already with the resistor and harness setup but they crapped out recently so I decided to try this new version out. The light output is the same but the unit is so much smaller now and only one wire per light versus two.
The bulbs are not the traditional twist ins. There is a rubber boot around the bottom so you can just push them into the socket and they seat pretty easily.
The plastic base that plugs into the wire socket is a tad too thin so you have to bend the wires out just a touch to make them contact the leads inside the socket. Once I did that, they’re working just as they’re supposed to. I have LEDs all the way around and no hyperflashing.
Overall, I would definitely recommend these as an upgrade from stock or even if you’re still running the old load resistors. The load resistors do the job just fine but these are pretty solid.
Only downfall I see is that if the bulb goes out, the whole unit must be replaced as it is permanently put together. But at $20 a pair, it’s not that big of a downfall.
Oct 10, 2018
Changed out and back on the road.
This part was exactly what I needed to get my Harley back up and running. I highly recommend changing out this part if you are changing your fuel filter or pump. The stock plastic piece will wear down over time and not hold tight enough to generate the needed fuel pressure. $20 and it fixed it right up.
Jul 20, 2019
Good looking grill with a little work.
1 of 1 found this helpful This grill fits pretty easy where it’s supposed to. The lower clips don’t seem to want to stay in their place but the four bolts hold it in just fine.
The middle mesh part is a separate piece than the surrounding so it made painting much easier considering I wanted them two different colors.
The nuts on the back of the grill that hold the middle piece in will rust overtime so keep an eye on that if you have a light colored paint so it doesn’t stain it.
Solid fitment for an aftermarket piece.