About
All feedback (578)
- n***d (455)- Feedback left by buyer.Past yearVerified purchaseArrived quickly and well packed and is as described thank you
- h***e (775)- Feedback left by buyer.More than a year agoVerified purchaseA1-Speedy delivery along with good communication-Great care with packing- Recomend
- calsport-1 (108191)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with from calsport.co.uk
- *****- Feedback left by buyer.Past monthVerified purchaseExcellent ebayer, fast payment, valued customer, highly recommended!
- royalvide (5602)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- xpower-eng-ltd (19483)- Feedback left by buyer.Past 6 monthsVerified purchase10/10 A Pleasure To Do Business With. Thanks From Xpower Engines
Reviews (5)
Jul 27, 2017
Not just a sticker
Please bear in mind these are genuine stickers for exhaust systems and are metal foil and not cheap plastic copies. Remember when installing these that they have a lot less give because they are foil stickers and will crease if you peel the backing off at a steep angle (i found out the hard way on one). Make sure you lay on a fairly flat surface with a gradual radius. You also have to put them through a heat cycle for the glue to stick fully. You can put them on other parts like any other sticker but i would probably use a hair dryer to set the glue. If you are going to spend £500 - £2000 on an Akrapovic exhaust make sure you buy the genuine stickers. I bought these as i had to remove the logo covers to be able to fit the pannier racks on the rear.
Feb 12, 2017
Great dual purpose tool
1 of 1 found this helpful I bought these to change my tube type tyres / tires on my Yamaha XT660z adventure bike. Replacing the 17" rear was a lot of work but these levers enabled me to break the tyre bead within minutes. I was working on my garage floor so didnt have the best levarage. I ended up levering the bead breaker down to the floor then used one leg on the bars and the other leg on the opposite side of the tyre to lift it up and break the bead. I had to repeat the process a handful of times to get the bead to eventually "pop" but as a complete novice i realised i hadn't used enough soapy water. The levers are big and chunky and do not bend even with my 100+kg weight on them. I noticed the black coating comes off the tool tips pretty quickly but it is to be expected with a metal on metal tool. I would recommend to anyone who doesnt have the space for a bead breaker and may be of use out on the road and would certainly make space on my bike for long trips (although they are too big for most standard tool tube/tool bags).
Jul 19, 2019
Poor finish
The fins were absolutely fine and the fit was ok. Unfortunately where the top meets the rear there was a massive blob of glue and carbon fibre so looks terrible