About
All feedback (325)
- prm-77 (59)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- best-guitar-decals (318)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bennyblancoguitar (514)- Feedback left by buyer.Past 6 monthsVerified purchaseFirst class. Thanks
- *****- Feedback left by buyer.Past yearVerified purchaseGreat communication. A pleasure to do business with.
- tecbitsuk (5229)- Feedback left by buyer.Past yearVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- graduateha7 (18560)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (25)
Jan 16, 2019
Useless!
2 of 2 found this helpful I can not get these to do the job no matter what! The sizing gauges do not correspond to anything The cutting surfaces are simply semi-circular cutouts with no real edge because the thick coating covers the so-called cutting face and so they do not cut at all. Because the jaws are not straight, If you put any effort into the mix, they will simply slip and cross over each other, maybe leaving a dent in the wire's insulating cover and taking an effort to unjam them. The cutters will not grip or cut the wire at all. That's about it! Useless!
Jul 22, 2018
Not up to the job.
Very delicate and do not stand up at all well to fine repositioning without wrinkling or tearing. They were NOT SEALED like most aftermarket decals and this was not pointed out. If you even gently dab the decal with a damp tissue to get rid of wrinkles and bubbles. the print comes off VERY easily.
Although they are thin (maybe too thin) they seem to leave a very obvious edge.
Three of them disintegrated while being gently positioned or excess water being (delicately) dabbed off, something that I have not had any trouble with before with other decals.
Mar 30, 2019
Good idea, needs work! ...
0 of 1 found this helpful Excellent idea but falls short of the mark...I found these to be too thick for the job, raising the neck angle a bit too far, I know that you can adjust bridge height and so on, but only so much!
I understand that veneers only come so thin but these are a bit too thick.
Most necks only need something about the thickness of a couple of folded rolling papers or a couple of layers of thin card so these need to be a good deal thinner, even if too thin you can always build one on top of the other.
If these guys can work on making them thinner or even wedge-shaped they will be on to something!