solarking4 on eBay

About

Location: United StatesMember since: Apr 25, 1999

Feedback ratings

Last 12 months

Positive4- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (302)

julyhomemi (718)- Feedback left by buyer.
Past month
Verified purchase
Hope you enjoy your purchase! We greatly appreciate your business!
integritytech (23922)- Feedback left by buyer.
Past month
Verified purchase
We buy back broken Lorex Cameras! Thank you
lemon4856 (2014)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent--super quick to pay. THANKS!
7***i (418)- Feedback left by buyer.
More than a year ago
Verified purchase
Shipped quickly, safely and as described.
cjstoilis (23111)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for your business!
0***l (1817)- Feedback left by buyer.
More than a year ago
Verified purchase
Item just as described, happy with purchase. Thank you!

See all feedback

Reviews (1)

RZR Lower Door Inserts Panels For Polaris RZR XP 4 1000 900 Turbo 2014-19 4Door

Mar 19, 2019

Fits XP4 Ride Command with Door Speakers

These look like the factory Polaris doors for less than half the price. They fit my 2018 XP4 Ride Command with door speakers. The fit up problems that occurred had nothing to do with the Ride Command speaker panels. I had to modify the holes and adjust 2 doors. Also be prepared to grind some of the door skin plastic to provide clearance for them to shut. Overall I’m pretty happy as the fit is as good as some factory door lowers I installed on my 570 single seat ACE’s. Be sure to loosely install the new frame then the lower skin to check the fit to the door sills. Then put your factory door skins back on and then lastly adjust the door bolts if needed. You will need to trim some plastic with a Dremel or air grinder. I also had two frames that did not fit up well. One I tweaked a bit and the other I opened up the holes in my factory door frame. Remember that the lower skin and the factory outer skin may have a gap between them so don’t expect a tight fit. I probably didn’t need to open up the holes on the rear door frame but I was expecting a tighter lower skin to upper skin fit. Try and loosen bolts and also note the sequence in which you tighten them has an affect as well. I’m probably going to stuff a rubber seal in there to keep water out. The Z brackets that fit on the front doors by the latches do not line up well at all and need to be bolted up first before you tighten the other two at the bottom of the factory door frame. I had to tap one of the holes on a rear door frame as the threaded piece on the back side was welded in the wrong spot. Still a good deal to be had here. Happy installation!

See all reviews