About
All feedback (798)
- moe-tech (18824)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- eliteautotech (365)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- autotattoo_direct (5301)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- dt_moto (518932)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat buyer, fast payment, nice to deal with !!!
- cacsalesllc (73760)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- quality_oem_inc (12731)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (7)
Feb 19, 2018
Nice fender!!
This is a great fender. Built well from 14ga steel. What I really liked is that it’s a stamped piece with no seams welded down the middle like cheaper ones on the market. That ensured that I’d spend much less time on bodywork. In fact all I had to do was use some high build primer, sand a couple of minor stamping lines near the tips and it was ready for paint. I undercoated the bottom just to be safe. Included spacer brackets were a nice plus...just had to get some longer bolts at the local big box and I was good to go. Fit perfectly and really opened up the view of my 21. Exactly what I was trying to accomplish and I recommend this fender over the cheaper ones out there. Fiberglass can crack especially with the vibration inherent to Harley’s so that’s another point to consider. Highly recommend going this route...built like a tank and worth the money!!!
Apr 24, 2018
Worked well on my 2012 VW Jetta
1 of 1 found this helpful No issues with this kit...worked well and the trim matched my dash perfectly. The antenna adapter is a single Fakra connector whereas my car had a dual Fakra on the oem radio. I connected it to the corresponding side (only plugs into one of the two slots since they're different) and FM reception works just fine...haven't tried AM because I never listen to AM radio anyway so not sure if that works...don't care actually. Wiring connecter latches onto the factory side perfectly as well since VW uses a specific latch style system that has a locking cam lever. CanBus doesn't integrate into it but most stereo's other than stock utilize CanBus to communicate with the radio. Red power lead included needs to be run separately to the fuse box to an ACC on location...easy enough to find an empty slot with a light tester. They do this to avoid issues with the CanBus throwing errors by using it's power through the harness...CanBus delivers power for a little while after the car is turned off and they avoid any communication errors doing it this way...works for me. Overall, I recommend this kit for doing an aftermarket stereo without having to cut any original wires.
Nov 05, 2018
Great hitch for the price !!
Got this hitch for my wife’s 2012 Edge. I installed it in about 1.5 hours by myself. I used ramps on her Edge and a motorcycle jack to raise the hitch into place getting it close enough to lift one side at a time to get the nuts started onto the carriage bolts. Another helping hand would’ve cut the time down, but I managed just fine. Threaded fishing wires worked well to feed the carriage bolts and plates into the existing frame holes through the small cutouts at the rear of the frame rails. Had to drill two required holes for the back section of the hitch but that was surprisingly easy as well. Just follow the included instructions and you won’t have any issues. I’d recommend this product.