rreed87139 on eBay

About

I pay almost immediately, expect the product described, want timely responses, provide feedback.
I try to post a fair price. Try to ship immediately. I track till delivered. Look for feedback to know your happy.

Location: United StatesMember since: Jul 14, 2001

Feedback ratings

Last 12 months

Positive10- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (423)

pmsutahorg (22713)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Check out more at pmsutah.org
powersportusa (5737)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
maddparts (19167)- Feedback left by buyer.
Past month
Verified purchase
Thank you for your business.
cooldrivestyleparts (19)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
fcrvmarine (21495)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.A++
coronagems1 (12306)- Feedback left by buyer.
Past month
Verified purchase
Great communication. A pleasure to do business with.

See all feedback

Reviews (6)

Bitzenburger Dial-O-Fletch Arrow Fletching Jig Model S in Box

Apr 08, 2021

Works great

Made well and good adjustability. Easy to use. Setup documentation could be better. Replaced fletches and they were aligned perfectly with my factory installed vanes right out of the box.

Traxxas 3652A Blue Alum Rear Stub Axle Carrier Stampede 2WD Slash Rustler Bandit

Oct 20, 2016

Garbage

The bearings do not seat in these axle stub carriers. You can actually spin the entire outer race of the assembly inside the axle stub. When you start driving around the bearings will also move side to side in my case they slide out about a 1/16th of an inch left to right. I had to add three washers to hold them in place but I'm sure they are still spinning. I'm removing them because they will destroy bearings in no time and probably seize up on the drive shafts and damage the differentials, transmission, and motor. The traxxas tech support guy, Chris, tried to tell me bearings should slide all over the place' they are hobby grade, and then got ticked off when I told his that is incorrect. I put a bearing in this axle stub turned it over and the bearing fell out and rolled away. I put the other side in and it fell out. They race spins inside the axle stub, and slides left to right on every bump. You can actually push the down on the car and see the bearings go in and out. You'll be putting new bearings in every day. Because the entire steel bearing assembly with shift left to right and spin inside the axle hub freely while your going 20-55mph in a something like a Slash VXL the next bearing will probably have a full millimeter of free play. I don't know how fast the axles spin but the Brushless motor rotates at 48,000 rpm on a 3 cell lipo and if your bearing is spinning and sliding around your going to bust a lot of stuff. The RPM plastic and the Traxxas stock axle stubs are much better. For well under half the price of these things.

Traxxas XO-1 Wire Retainer for 3792 Gear Cover TRA6537

Jun 01, 2016

Nice sturdy mount

Easy to install works great.

See all reviews