About
All feedback (172)
- regan0331 (39090)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- snaptech (43519)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (3)
Jan 02, 2018
Not For the Beginner
I already have a i3 clone, wanted a printer with bigger printing area 300 mm vs 200 mm. If you already have some experience with 3d printers, you should be golden, assembly was tricky with included instructions, (internet is your best friend) missing 2 grub screws, one for frame, one for flexible shaft coupler, angle support holes were too big for supplied screws. over half of supplied screws threads were bad, missing 6 "T" nuts for 2020 extrusion. ended up just ordering 2 screw sets, washer sets, "T" nuts and grub screw set. Once I finally had unit together and aligned, I had to change some of the parameters. Approx. 2 weeks later (To get parts together) and its printing beautifully. like i said, not for average beginners.
Mar 29, 2017
Crystal clear water in one week.
3 of 3 found this helpful Using it on 40 gallon aquarium, upgrade from standard trickle filter. Unit came with everything needed to start. Ceramic, bioballs, charcoal pouch and filters. Took me 30 min or so to set up, soak the hoses in hot water to make them easier to straighten. About a week and tank water is literally crystal clear and fish are more active. I definitely recommend.
Oct 08, 2017
Works, Just not as expected.
Will not work attached to side of XBOX , conveniently came with a USB extension cable, if you plug it into the back ports it works fine. Better off getting a different USB external enclosure you can hide easier. ill keep it because i dont care about aesthetics as much.