About
All feedback (547)
- darisusgmbh (73262)- Feedback left by buyer.Past 6 monthsVerified purchaseVielen Dank für Ihren Einkauf. Sehr gern einmal wieder.
- ht-imex_de (19791)- Feedback left by buyer.Past 6 monthsVerified purchaseSeriöser Käufer, prompte Bezahlung, geschätzter Kunde, vorbehaltlos zu empfehlen
- ipertronica-it (118698)- Feedback left by buyer.Past yearVerified purchaseComunicazione ottima. È un piacere fare affari assieme a lui.
- storehobby (1586)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- jk_parts (126305)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- skleptechniczny_de (36430)- Feedback left by buyer.Past yearVerified purchaseReibungslose Kommunikation. Sehr angenehmer Geschäftspartner.
Reviews (7)

Jul 03, 2019
Hp G62 Intel I5 motherboard
1 of 1 found this helpful This was the first time that ordered motherboard came without any problems and 100% working.
Motherboard is direct replacement for AMD processor motherboard but keep in mind that you will also have to source Intel I5 processor and heat sink for it. The bad side is that graphic performance will be little lower but you will have still nice reliable laptop without overheating problems due to insufficient cooling

Jan 08, 2018
Test leads
I bouht one bunch of these more from curiosity than to expect to be useful. Aligator clips are quite strong but wire gauge is so small that the leads can be used only for low currents. Also they are not properly crimped or soldedred to the clips.
Can't recommend them by any means.

Sep 27, 2018
Resistor set
1 of 1 found this helpful I've ordered a packet of these to have wide range of resistors for quick prototyping. I've measured some pieces from every set to see if they are within the 1% spec. What I found out is that values on some pieces are out of this range but well within 5% range. Also the leads are much thinner than on good (more expensive) resistors which could be a problem to use them on a breadboard.
Would I recommend this set. For applications in which you substitute carbon film resistors with these yes.
For applications where you need accuracy no, unless you measure and select them before assembly.