About
Reviews (1)
Jun 05, 2019
With a little attention to detail when designing the mold, this could have been a 5 star product.
These Handles work and seem to fit ok, but when you release the handle it doesn't retract all the way flush against the door, as well as one of the two handles I installed had the gasket between the two pieces that fell off before the installation process was completed. There is no doubt in my mind that the gasket on the opposite side will fall off as well in a very short time as well.
The handles retracting fully flush against the door could be very easily remedied with a slight reduction in a small amount of the rear rectangular part of the handle that goes through the door.
We are only talking about .35mm outward towards the handles grip surface. That reduction would only need to be 1.35mm in length from the handle grip inward.
If I were the Quality Control Administrator of this product, it would get a 100% 5 Star Rating 99% of the time with virtually no added cost. It's so simple to make a quality aftermarket part.
I have been the director of fixed operations for automotive new
car dealerships, as well owned 7 Collision Repair Centers myself, as well as do consulting for Automobile manufactures solving problems just like this.