About
All feedback (62)
- 4phil-bush (5205)- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- merchandisemecca (71126)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- cartridge_man07 (18131)- Feedback left by buyer.Past 6 monthsVerified purchase▄▀▄▀▄▀ ₪₪ ►►► Excellent Ebayer ‹(◕‿◕)› Thank You! ◄◄◄ ₪₪ ▀▄▀▄▀▄
- marvingardenz (135)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick payment. Thank you!
- jasondyoung (79)- Feedback left by buyer.Past 6 monthsVerified purchaseBuyer paid promptly, was very considerate and reasonable! Had no issues at all, and would definitely do business with again!
Reviews (2)
Aug 06, 2023
Good
Stops my trailer. Easy to install. Not missing anything. Not much more to say. Exactly what I expected, nothing more, nothing less.
May 30, 2017
Surprisingly good for Chinese
Pretty tough. I'm using these in a Glacern FM-45-200 facemill on a bridgeport and they do well. I'm horsepower limited so my average cut is about 25 thou deep. I'm good at breaking carbide but they do hold up well. I've accidentally bumped an axis and drove it in hard, stalled the mill, etc, and that didn't phase them. The only thing they don't like is cast iron. I always seem to chip them when milling that. Little chips, they don't affect performance too much, but I try to stick to steel and aluminum. They do a great job on both of those. If you get your RPMs up, the finish is like butter smooth, even on steel. They seem to do fine around 1500 SFM, but I stick to much lower on my rough cuts, and typically around 1000 for finish cuts. The price per edge is good.