About
All feedback (1,172)
- machinery4wood (23202)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- worldofbooks08 (10347013)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- happyeasybuy03 (85406)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- h***h (2133)- Feedback left by buyer.More than a year agoVerified purchaseThanks for this, I've always wanted to try out one of these controllers. Came well packaged and in good time. Looking forward too putting it through it's paces. Thanks Again :D
- *****- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- 8***3 (49)- Feedback left by buyer.More than a year agoVerified purchaseArrived early, well packaged, would buy again. Would recommend A+!
Reviews (4)
Mar 15, 2018
Zero stars if i could!
2 of 2 found this helpful This toy holders packaging clearly shows it stuck on a 90 degree wall. You can imagine my surprise when i tried to put it in the corner above my bath that only 3 of the suckers made contact with the wall at any one time.
Speaking of the suckers, they are completely flat and provide no suction at all. So the "wall mountable" holder cannot be mounted on a wall for 2 reasons!
What a piece of poorly designed rubbish. Complete waste of £4.99.
As the title suggests, if i could give this product zero stars, it would be too generous!
Aug 14, 2018
Cracking piece of kit
1 of 1 found this helpful Once assembled, cut straight and true 1st time. Didnt even need aligning (i did check).
I only have a few issues.
1. The laser guide line is about 2mm from the edge of the blade.
2. The multi material blade leaves quite a bit of tear out on the back side of the wood.
3. The assembly instructions are not 100% clear.
4. The rear nut was on so tight that i was unable to change the angle for bevels.
Fortunately, all but 1 were easily fixed. I replaced the blade with an 80 tooth blade, now it cuts beautifully.
A small modicom of common sense over comes the instruction issues.
I loosened the nut at the back so it pivots.
All in all, a bloody good piece of kit that i would happily recomment to anyone who asks.
Fortunately
Aug 08, 2017
Oh dear
Yes, there is only a gap of about 4mm each side to the edge of the screen.
However, as the S8 screen starts to curve about 8-9mm from the edge, that means there is a curved area under the protector where dust and debris can get under as there is little/no contact.
Also, the gap at the edge makes it much harder to use the "q" and "p" keys whilst typing.