About
All feedback (844)
- befreetech (4836)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- services1990 (26531)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- yiiooy (1582)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- quirkparts (1027540)- Feedback left by buyer.Past monthVerified purchaseThank You From Quirk Parts! Come Back Again For Great Automotive Deals!
- scdire-28 (151)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- clt_obd_14 (16)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
Reviews (4)
Jun 04, 2019
Good OEM replacement cable
Perfect form, fit, and function replacement for the Traction Drive Cable on my Toro Recycler 22.
Jan 09, 2018
difficult with instructions, impossible without
4 of 4 found this helpful Some vendors sell this kit with assembly instructions. Mine did not, but I managed to find enough information to put it together. Be prepared for surface-mount components, but they're 0603, maybe 0805, so it's not as hard as you might think. Until you get to the toroid ... a very small core, that you have to wind with wires thinner than a hair and solder onto IC pins that are less than 20-mil spacing. This is virtually impossible without a microscope and a very fine-tipped iron, and extremely difficult even with them. I eventually managed, but I have yet to have any success with HF, and yes, I'm using a long-wire antenna, and I've tried the I and Q modes and every other setting I could think of in HDSDR and SDR#. Maybe I did a lousy job with the toroid, maybe it just doesn't work (it does work fine on VHF and UHF, just like any other, simpler RTL2832-based SDR), but there are pre-assembled versions of this available for about the same price as the kit. If you decide to try this thing, I strongly urge you to avoid trying to build it yourself, regardless of how much assembly experience you have.
Nov 29, 2021
High quality at a reasonable price
The fit was perfect and, based on the lack of vibration while driving, it is well balanced.
I had to replace the driveshaft on my Mazda RX-7 at 175k miles previously and did not go with Dorman, but instead went with a driveshaft that had grease fittings. I could not easily access the front U-joint to lubricate it so, perhaps as a consequence, the U-joint failed after only 25,000 miles. The Dorman driveshaft has no grease fittings, and I consider that to be an advantage -- after all, the OEM driveshaft lasted 175k miles, and it didn't have grease fittings either.