john_man_25 on eBay

About

Location: United StatesMember since: Mar 02, 2001

Feedback ratings

Last 12 months

Positive26- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (626)

*****- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
pogomotionz (3827)- Feedback left by buyer.
More than a year ago
Verified purchase
Very fast payment. Great eBayer. Would do business with again. A+++++
morpowerequipshop (6203)- Feedback left by buyer.
Past month
Verified purchase
Great communication. A pleasure to do business with.
piedm21 (2243)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
hawk055 (5330)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent Buyer. Super-fast payment. Pleasure to do by with. Come back anytime. Recommend to all. A++++
dopamine-decor (148)- Feedback left by buyer.
Past 6 months
Verified purchase
Good transaction

See all feedback

Reviews (7)

Carburetor Carb Replaces Tecumseh 632795A Fits TVS90 TVS100 ECV100 TVS105 TVS115

Jun 13, 2016

Affordable Chinese Knock-off

It's cheap, and it works. You'll need to do some tuning to dial it in, 2 turns out from seated is a good place to start on the main jet. Float Needle and seat are metal to metal unlike traditional (real) Tecumseh carbs, which this isn't.. But hey, it works. So far...

NEW SR Suntour XCT XCM XCR EPICON Front Fork Repair Tool Wrench MTB bicycle tool

Jul 29, 2017

Works Well

I was a little sceptical because it is made of plastic, but it sufficiently strong for the job. It also fits some of the cheaper Suntour forks like the M2025 which is what I used it for.

Danco 4S-2H Hot Stem for Milwaukee Faucets 17241B

Feb 24, 2018

4S-2H stem works for a while

I've bought both the Danco and CPI versions and they usually start to leak again. You can extend the life by taking out the center part of the valve and polishing the seating area on a flat surface and very fine (1000 grit) sand paper, then chamfering the 2 water holes with a drill bit so they don't wear out the rubber seals. If seals are already shot they are replaceable.

See all reviews