japsniper1980 on eBay

About

Location: United KingdomMember since: Nov 05, 2003

Feedback ratings

Last 12 months

Positive22- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (763)

n***u (1024)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for accepting my offer. Brilliant transaction. Items brand new and exactly as described. Quick despatch and delivery. Absolutely no hesitation in using again or recommending this trader.
bounding (20813)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
popularcitynew (12354)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
m***d (60)- Feedback left by buyer.
More than a year ago
Verified purchase
Great service and communication. Products as described. Would recommend and buy from again.
worldwidelectro (64289)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
clearance101 (1864)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (2)

New Renthal Road Race Motocross Enduro Quad Handlebar Grip Glue 25ml

Mar 29, 2017

Too thick and doesn't last

I needed this handlebar grip glue to stick down my new Oxford heated grips to my bike. The glue is very thick and when you slide the grip on it pushes most of the glue to one end, which means most of the grip is not stuck down. Sure enough my clutch side grip came loose after my first ride since installing the heated grips. I left the glue to dry for nearly a week. So I tried a second time, and it failed again. I cleaned up the handlebar on both occasions, and applied an even spread of glue. The third time I restored to super glue, which sure enough is nice and thin and has held the grip down perfectly. For some reason this glue worked perfectly on the throttle side, so it have a 50/50 failure/success rate.

0 of 1 found this helpful

Radiator Hose Bleed Vent Screw Plug Bleeding For BMW 3 Series E30 E36 E46 Mini

Nov 22, 2018

Much Better Than the OEM Plastic One

I'm pleased I replaced my plastic OEM bleed screw with this brass one. My old one was getting to the point where either it was going to crack (as plastic can do over time), or the top would break and I'd need a pair of pliers to get it off. For only a few pounds you might as well swapping this over. I just wish there was a replacement one for the bottom of the radiator as well.

See all reviews