About
Reviews (1)
Jul 03, 2019
So far it's a fancy piece of junk I hope I can use ...
It looked fine until I started to assemble it. The plastic pieces were twisted into place and did not fit well. I had to drill out all the holes to make them fit. The access hole to hold the shaft still while you tighten the grinding wheel bolt was 1/2 in off location and had to be redrilled. The two bolts holding the chain guide together were over tightened so bad the bolts were stripped and now need to be ground off and replaced and I still haven't gotten it running to see if it will grind yet.