About
All feedback (160)
- vivosun-us (8563)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- crownkirkindustrialllc (638)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for your business. We look forward to doing business with you again.
- shenzhe10 (1581)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- sstindustrialsolutions (30825)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for the order. Look forward to dealing with you again! SST
- 1967caveman1 (3469)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- rasangprasa-0 (133)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
Reviews (4)
Apr 10, 2019
These must be wired up with 2 units in series to run on 3.33 volts without having them fail after short run time
These will fail at 3.33 volts after short amount of heavy run time & don't expect to get any kind of run time on 5 volt supply as they will fry in less than 3 minutes on 5 volts.....
After some messing around with these to find out how to get the best results and best duty cycle out of these modules you must wire up 2 units with the input and outputs wired in series as they will hold up great on 3.33 volts if wired in this manor
Apr 20, 2019
There Junk
0 of 1 found this helpful Base plate broke in less than a month longboard application so yeah there junk
Jan 07, 2021
Ehh could have been better
The item was not packaged very well it only had wadded up paper around the alternator and not a molded styrofoam piece around it like it should have had in fact it was so poorly packaged that apon inspection of under the plastic back cover I noticed that the brush box was broken and when I took the back cover off to inspect it even further it was in fact broken all the way through and would have failed within a day had it been installed on a vehicle so I ended up crazy gluing it together until I get a new brush holder also the rotor fits loosely inside the inner races of the bearings showing that no one used locktite in this rebuild and its not press fit like a brand new one would have been overall its a poorly rebuilt and packed item