hunp_27 on eBay

About

Location: United StatesMember since: Sep 30, 2019

Feedback ratings

Last 12 months

Positive1- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (12)

netsellerzoc (46984)- Feedback left by buyer.
Past year
Verified purchase
FANTASTIC buyer, thank you for your SUPER fast payment. You are 5*****
ebl.direct (177977)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
pops1stopshop (2039)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
pavel.r79 (645)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for your purchase.
wheatridgeresells (366)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you!
affordablemerchandise (1085)- Feedback left by buyer.
More than a year ago
Verified purchase
Great Transaction & Fast Payment. Thank you for your Purchase.

See all feedback

Reviews (2)

ICM271 271C FURNACE CONTROL BOARD REPLACES CARRIER HH84AA010 011 012 012 020

Sep 08, 2021

Furnace blower now turns off completely at the thermostat.

Furnace blower remained on in low speed after AC was turned off. As a temporary solution I had to turn off the power at the furnace. I suspected the problem was the old HH84AA011 Carrier control circuit board. The only issue is the GAS1 to GAS3 jumper from the old board will not fit on the ICM271. The spade prongs are too far apart. So all I did was to solder a jumper wire on the corresponding terminals on the solder side. Now blower shuts off completely at the thermostat. I awarded 4 stars because old board jumper does not fit new board.

AS-IS Non Working Philips Sonicare HX6210 Electric Toothbrush Handle Only

Nov 17, 2023

Rejuvenated an old product

All I had to do was to install new rechargeable batteries.

See all reviews