About
Reviews (5)
Aug 16, 2021
I have to cancel my pest control agent.
During the summer, my house is infested with ants. A pest control salesman was cruising my block and I signed up because I was so fed up. On the first treatment, they gave disclaimers about the eggs and larvae and whatnot so I still expected ants. We still had lots of ants. When I found this, I bought it to use in conjunction. After the first treatment of the Demon Max,. I saw ONE ant, probably a straggler from inside. It's been 2 weeks and there isn't a sign of a single ant in the house! I'm cancelling my pest control agent ASAP. Btw, the bottle isn't large but a little goes a long way. You mix like 2oz or Demon Max to 1 gallon of water. It was enough to go around my 1500sqft home with about 1/3 left over.
Dec 07, 2017
Good slitting saw
This blade is pretty large for a 3/8" arbor, but this was just what I needed. I had a hard time getting this on my NEW arbor so the issue was either arbor was too big or the hole on the saw was too small. I measured both and they were both exactly 0.375" on the dot. So I lined everything up and slide it on slowly and it DID fit, so as long as the length of each tooth (I haven't tested this), there won't be any wobble with this saw blade.
I have yet to use this blade more and see how long it lasts, but so far so good.
*** Update ***
I had a change to use this blade. It's closer to 0.05" 0.055" than 3/64 (0.047"). There are variations between teeth, but its not too bad. At times, there is a lot of chatter but that's mainly die to a less-than-idea setup than any issues with the blade. In spots where it's closer to the jaws, it cuts like a champ. I'm ordering a few more of these.
Dec 29, 2016
Product Applies Well But Bot Properly Delivered
I have not yet fully tested this product, but my first impression is this:
The product was HOPEFULLY cut to length, but delivered in a cardboard tube with white plastic end, which allow plenty of light to come through. These should be delivered in a black light-proof bag, and anything outside of that should be ok.
I've used a laminator to apply the product onto a FPCB and it looks pretty good. I have not exposed it or developed it yet, but I have a feeling it MAY work out OK, however, for longevity, it should be delivered in a light-proof bag.