It takes a while to get used to, but overall, it's not a bad item. I will say that it is lighter than the conventional Bi-pod (which I previously had) on my other AR.
"Good Value"...Hmmm...that depends on how much you spend. $20.00 is fair.
I paid more than HALF of what others are listing this for, INCLUDING FREE SHIPPING w/LIFTGATE!
I started this (break in) w/NO LOAD and it idles flawlessly.
The ONLY flaw, is the weight of this generator causes flat spots on the tires.
Spend the time to HUNT for 6/4 50 amp cable & connector. Just yesterday I purchased 25 ft of 6/4 & a female connector (3prong, 50 amp) for under $90 incl. FREE SHIPPING.
Home Depot sells wire (6/4), but for much more, esp. if you want a pre made cable (w/connectors).
Time spent was well worth the savings!
Riser Mount Low Profile 0.5 Inch 13 Slot Picatinny Weaver Rail Flat 1/2 in UTG
May 04, 2017
This riser works better than I expected!
I became sick & tired of shooting my AR w/iron sights and having to plaster my face on an uncomfortable stock.
So, I purchased a Vortex scope and this riser...WHAT A DIFFERENCE!!!
Raising this just a 1/2 made all the difference in my shooting and comfort. My face doesn't hurt any more! LOL
Of coarse, you'll have to compensate, for the additional 1/2" rise PLUS the height by the scope mounts, but this makes for a more comfortable shooting experience.
The ONLY downfall, is that you cannot just tighten this with your fingers. After 1 30 rd mag, the mount will loosen. A coin will take care of that.