handyben on eBay

About

Location: CanadaMember since: Aug 03, 2000

Feedback ratings

Last 12 months

Positive12- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (916)

allkinds4allsorts (2504)- Feedback left by buyer.
Past 6 months
Verified purchase
Smooth transaction, thank you for your order.
8ten1944 (245318)- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
vehicle_part22 (6051)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
a-premium-us (69039)- Feedback left by buyer.
Past year
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
a.c.autoparts (1751)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
chemical.warehouse (3165)- Feedback left by buyer.
Past year
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

See all feedback

Reviews (3)

23pc FWD Front Wheel Drive Bearing Removal Adapter Puller Pulley Tool Kit /W Cas

Jul 12, 2016

A bit heavy but certainly does the job well

I used it to replace the front wheel bearings on 2005 BMW 325xi (AWD). The old bearings were in there quite tight, but after taking out the hub flange using a slide hammer, I managed to remove the bearing with this tool kit without having to remove the bearing carrier off the car. The 32mm bolt head and nut require a large wrench or socket to drive it, luckily I had those on hand. I needed a 2' long breaker bar to break the bearings loose. I found the perfect size adaptors for both removal and installation of the bearings. Highly recommend this tool kit.

Transfer Case Shift Motor/Actuator 2011 Range Rov Sku#2369184

Jan 26, 2021

Land Rover Transfer Case Actuator Motor

Item performed flawlessly.

4993 AC A/C CONDENSER FOR BMW FITS 525I 528I 530I 2.5 2.8 3.0

Jul 26, 2016

AC condenser for 2000 BMW 528i

The good : the condenser worked fine, just like OEM, at a fraction of the cost. The pipe joints fit perfectly, so there was no leaking problem and no alignment problem either. The bad : the spacing between the 'trunk' and the return line is off by almost 1/4" compared to the original, this caused a problem, since the mounting bracket had a slot opening that fit the old condenser, but would not fit this one. I had to use Dremel to cut the opening wider so the bracket would finally fit. This mounting problem was the reason I gave only 4 stars for an otherwise excellent product.

1 of 1 found this helpful

See all reviews