gumball52 on eBay

About

Location: United StatesMember since: Sep 09, 2003

Feedback ratings

Last 12 months

Positive17- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (268)

beseensales (200)- Feedback left by buyer.
Past month
Verified purchase
Thank you! Great working with you!
kara_kat (1453)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for choosing my listing. Great communication.
thetubedude (736)- Feedback left by buyer.
Past 6 months
Verified purchase
Thanks! Please visit again A+++
rae-n-eddiescloset (2979)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
resaleretail_16 (337)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
shenanigans (2321)- Feedback left by buyer.
Past 6 months
Verified purchase
·:*¨¨*:·.★☆Super eBayer★☆.·:*¨¨*:·.★☆Thank you★☆.·:*¨¨*:·.★

See all feedback

Reviews (3)

SiriusXM NGVA3 Magnetic Antenna Mount for Your Vehicle

Dec 27, 2020

Great Product

The unit is so small I doubt if it even affected any aerodynamics of the car. This siriusxm antenna allows me to swap my aftermarket radio to my wife's car. I hid all of the wiring under the interior panels in my vehicle so this second antenna allows my radio to be portable to another car. The magnetic mount holds good (my wife likes to drive 70ish). The fine lead wire is easily tucked under weather stripping to bring it into the car. We used it in a four door sedan, the long lead wire supplied should make the antenna usable in just about any vehicle. We still had many feet of wire left bundled and were able to tuck it under the front seat. This excess could get in the way if someone wasn't careful.

2 of 2 found this helpful

Fullerton 30202 X-Long Square Carbide End Mill 3/8" 4FL Uncoated

Aug 28, 2022

Good tools but not necessarily right for my application

I got these to mill out a pocket using a template. The flutes were quite long for this application, requiring me to take a full dept pass to avoid cutting my template. This plus I was using a hand feeding motion did cause a tip to break but I doubt it was all the mills fault. I think I was just using the wrong tool for my cutting.

42" Rotary #1032 Lawn Mower Mulching Blade Set (2) for MTD #942-0616

Sep 22, 2022

Good buy

Blades matched originals only cheaper

See all reviews