About
All feedback (38)
- thaironlion (1844)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (2)
Mar 22, 2016
Sticks so good that it bends stainless steel
I'm using this weld to stick the base of a solar tracking linear actuator to an aluminium frame. The weld is so strong that the bolt that I use to hold the actuator in place curved outwards due to the pull of the actuator (if the weld was weak, the base would have simply ripped off). I estimated the tensile force to be around 300 psi, far lower than the rating, but non-marginal. Bolting it would have entailed lifting the whole 20 lb setup - tedious, especially when it's on a rooftop far from any electrical plugs.
Do note that you absolutely need to follow the steps - wash the surface with clean water (I used MilliQ water from a lab), degrease it (70% isopropyl alcohol), abrade it (120 grit sandpaper), rinse with compressed air and repeat the cycle for good measure. If you would like to know why these steps are necessary, you can always do a quick readup on epoxy adhesion theory.
Great investment! Almost as good as welding itself.
Jun 15, 2016
Solid Bass
You can feel the thump of your music at half bass power. It's also very good at blasting music - barely 30% and 100 square metres were resonating!
Note that this is 110V, 60 Hz (I am in a different country so I had to get a small transformer).