About
All feedback (333)
- k***d (336)- Feedback left by buyer.More than a year agoVerified purchase this item consisted of a large number of vintage electronic items. While the vast majority arrived in very good condition, one item was damaged, due to inadequate, packing. The seller did have replacement parts for the damaged components, and I am in the process of obtaining them.
- h***_ (407)- Feedback left by buyer.More than a year agoVerified purchaseAll good. Boxes arrived trashed though. As all too often.
- superb-goods-4u (13438)- Feedback left by buyer.More than a year agoVerified purchaseThank you very much for your support.Welcome next visit, enjoy your purchase
- bgeras01 (657)- Feedback left by buyer.More than a year agoVerified purchaseThank you!
- boutiquelabrocanteuse (6571)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- bokehbros (6287)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (4)
Feb 28, 2017
MK9 extruder not so good an upgrade
1 of 2 found this helpful Well, it's better than the plastic extruder parts on the original - but the quality is just not at a usable level. To begin with, the cable ends may not match your controller board. My GT2650 has different receptacles 3 Pin while the fan supplied had a 2 pin - they don't match. Sure, you can try and cut and solder - hoping you get the right pins but that is not the solution. The heating block does have a two pin connector for the thermostat - but it's not the right one. You can re-use the heater plug by unscrewing it from the old heater and attaching the new wires. The loading lever is a great improvement that offers some adjustment, but I needed to ream out the holes in order for the filament to slide smoothly. Getting sweet spot where the filament would feed without skipping is an exercise in patience - or frustration - take your pick. A light push on the filament showed the mechanism was not feeding correctly and that it was not due to a jam or clog at that point.
In the end I never did get it print a part I could use - and now the thermistor has died on the heating block leaving me with an 'error mintemp' and a nonfunctional printer. The hot end does have a PTFE insert - but it is insufficient to prevent the filament melting in the barrel at a temp of a mere 205 for PLA. The result is after about 10-15 minutes the whole thing clogs up and you have another ruined piece. The little heat sink provided is an improvement over the non-existent one the stock end never had, but it could probably perform better with a second fan to cool it.
So I do not recommend this, better to put that money into a better design. After all, this is the heart of your machine.
Jul 05, 2017
Dyson cordless
Love this vacuum - but after less than a month and limited use - the battery will not hold a charge. Yes, it was a refurbished unit, but this is not the expected quality from such a leader in the field.
Mar 15, 2016
Boom Mike arm
2 of 2 found this helpful Good value for the money, comes with 3 wire mike extension cord installed, my Heil uses a 4 wire so that needed changing. Screw to tighten base is a little flimsy - but it can be held in place by drilling a ho;e and using a wood screw. Recommended.