gb_jb on eBay

About

Location: AustraliaMember since: May 17, 2007

Feedback ratings

Last 12 months

Positive10- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (97)

allfourx4 (64235)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
sparesbox_auto (536261)- Feedback left by buyer.
Past month
Verified purchase
Thank you for shopping with Spares Box. Highly recommend, valued customer.
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Perfect ebayer! Thanks from AB TOOLS ONLINE
allappliancesserviceandsales (17548)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer of All Appliances
tool_guide (18985)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
seakyland_au (3162)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (3)

Fuelmiser Ignition Coil Standard CC200

May 22, 2019

It's an OK product and will work

I have not actually fitted it yet but will keep it as a backup and I fully expect it will work when I need it. It appears to be of good solid build and the correct size to bolt straight into the original mounts. Price and turnaround time was very good. The primary coil resistance measures on an Ohm meter correctly for the Holden 202 HEI, which is the main thing electrically. The secondary coil should measure 8000 ohms (Commodore VH Gregory Workshop Manual is my source) but it only measures 5500 ohms. I'm sure the coil will still create a spark but likely not as "fat" a spark as it might have, due to the reduced ratio of coil turns.

Land Rover Discovery Defender Propshaft Nut Tool DA1119

Nov 14, 2018

Prop shaft nut tool for old landies and new!

My nuts were properly stuck on my old 109 series 3. None of my sockets had a thin enough wall thickness to get fully on the nut without burring it. The spaces are really tight and the new tool did the trick for the most part. I still had to angle grind off a couple off nuts. If the wall thickness was just a little less i might not have needed to do that but then the tool may not have been as strong in that case. Overall the tool made the job much easier than my past experiences doing this job. Cheers :-)

RTC3386 x3 Land Rover Series 2 & 2a Flexible Brake Hose Set Flexi Front & Rear

May 19, 2021

Good fit for 1971 2A

Have not fitted them yet, only offered them up and tested the threads in the wheel cylinders which are out for rebuilding. Still a way to go but these look right and have the right ends and lengths for my Series 2A 1971

See all reviews