About
All feedback (907)
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- mek-motoo (8317)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- e-city2008 (32840)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (40)
May 12, 2016
Top Quality!
Now, since the Taurus is made in Brazil, these mags are "foreign made" (Made In the USA). They fit fine and function 100% Great Value!
Jun 05, 2017
Solid Precision
The -AEU is made foe European dovetail cuts - for the Lyman / Investarms black powder rifles. They fit tight as they should. Follow the instructions to remove old sights by tapping out them from left to right, then installing the new sight from right to left. Use a wooden dowel or brass punch, and always tap on the sight base/dovetail & never on the sight itself. This sight and matching rear peep sight was installed on a new Lyman / Investarms .54 cal flintlock Trade Rifle. Accuracy is greatly enhanced. I can explode grapefruit placed out at the 100 yard line with it all day long.
Sep 03, 2017
Making it work
Quite often, when I'd pour in my inhalant liquid, the unit failed to produce an atomized output. The ultrasonic disk would only pass liquid drops. Sometimes, wicking it dry with a soft tissue would get it running, but more often not.
To remedy this, the Nebulizer liquid chamber and ultrasonic disc need to be clean and dry.
After use, I simply rinse the liquid chamber, then run some deionized water thru it for about 30 seconds. Afterward. I pour it out, then dry it with a can of compressed air of the type used for cleaning computer keyboards and electronics. Blow out the interior of the chamber slot of the little silver disc, then blow off the exterior surface. It is now ready for next use, and will start up right away when the start button is pushed.