About
All feedback (42)
- *****- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
Reviews (2)
Aug 05, 2020
Good for low volume air flow only
Even thou it has a 1/2" thread, there is a very small, ~1/16" hole that the air travel thru, to the volume of air is very low. The product is fine for low volume. I'm using it to drain automatically drain an air tank when I'm finished with the compressor, so in that application, it works find. It takes about a 1 minute to drain a 5 gallon tank. That give you an idea of how little the airflow is.
Jan 17, 2019
Careful with higher input and output voltages
2 of 2 found this helpful Be careful with this unit when using higher input and output voltages. Because of the way it steps the voltage up, Vsw peak on the XL6009 is the sum of the input voltage and output voltage and should be under 60V according the XSemi datasheet.
I'm using in an application where the input voltage will vary between 20V and 27.6V (yes, from two 12 volt SLA batteries in series) to drive a 30V 350mA load and I found the inductors and capacitors to get uncomfortable hot. The inductors are in dis-continous current mode because for relatively low 33uH inductors. I replaced the inductors with 470uH (because I had some), and it now runs much cooler.