About
All feedback (1,454)
- danlumu_0 (84)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- excessapparel (133048)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- samiisunflowerss-7 (3833)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- buy-08 (662)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- happlyseller (73832)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer! Highly recommended!! +++++
- aerostarfilters (13564)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (11)
Apr 11, 2016
Solved problem here is detailed instructions
1 of 1 found this helpful Hard to believe that these little plastic pads solved the problem of washer shaking and vibrating so badly during spin cycle. Quite easy to install if your mechanical. No you don't have to remove motor and transmission from unit, like one video on youtube shows. First unplug washer from outlet. Just remove top control panel (several different ways for different models) Either 2 screws on back or side plastic end caps pop off and screws are there. . unplug harness connector from top of cabinet. hang control panel itowards back. Remove cabinet by removing 2 clamp brackets, then tilting it forward towards you and off base.(set cabinet aside out of your way) Remove the 3 springs at bottom of drum.2 of the front/side ones just remove 1/4 inch hex nut to remove spring bracket and leave it hanging by spring. Rear, longer spring (motor counter balance spring) is easy to just unhook with needle nose pliers. Tilt drum back at each area of a pad and use a piece of 2" wood or similar to keep tilted and separated, while you pry old pad off and replace with new. Then move on to the next one. Be sure to clean the upper metal surface the contacts the new pad, with rubbing alcohol or similar. contact area should not be dirty or greasy. re-hook all springs and spring brackets. Replace cabinet Tilt onto front lip of base and back into place (toughest part). reattach electrical connector for control panel, replace screws to secure control panel (if it has them. Put washer back in place making sure it's level. Plug in and be amazed.
Jan 14, 2016
End to rust problem
2 of 2 found this helpful Used to cover our brass look rods that keeps getting rusty from moisture. looks nice and curtain slides so smooth and easy. No matter how often we replaced the rod and payed high prices and various finishes, they eventually got rusty or badly corroded. metal or plastic curtain hooks didn't make any difference. PROBLEM SOLVED.
Oct 15, 2024
master window switch for 2010 Sebring Li...
master window switch for 2010 Sebring Limited worked perfect and was in excellent condition.