About
All feedback (229)
- neslihan2016 (63)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for your shopping , I hope see you again 🙏
- jimmant-17 (255)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for a Smooth Transaction
- semisurplus (16517)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- miraclesale888 (33278)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bodyarmorgirl (2497)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- ltchardware (14978)- Feedback left by buyer.Past yearVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (5)
Oct 19, 2016
Great for sideways movement actuation
The roller plunger is perfect for when the actuation movement is from the side. That is, movement that's perpendicular to the plunger shaft.
Also, the shaft is long enough to provide good plunger depth adjustability. The shaft comes with two internal-toothed lock washers and two thin nuts.
The actuator has a crisp click and, so far, has been 100% reliable.
The electrical connection screws (6-32) are brass which provides a good, no-rust, connection. And they're clearly marked com, NO, NC (common, normally-open, normally-closed).
Well worth the money.
Be aware that if you use the shaft for mounting, you'll have to add notches in whatever bracket hole you make so that the roller will fit through the hole. No big deal, I guess.
Jun 14, 2017
Replaces OEM perfectly
1 of 1 found this helpful For my 2007 Odyssey, the tubing bends were perfect and the ends were correct. It came with the o-ring for the power steering pump end. It replaced my OEM hose perfectly. It's been installed for two weeks now and does not leak. You'll have to transfer the sensor and two rubber clamp protectors from your old hose. The price is less than a third of what AutoZone and Advance want for the OEM hose.
Mar 09, 2017
Works great for PC-board soldering
2 of 2 found this helpful For printed circuit board soldering, 60/40 is the tin/lead ratio you want. And0.8mm is the perfect diameter too. The rosin core seems to be acidic enough to clean the surfaces for a good solder joint. Delivery took two weeks which seems too long since it comes from California. Well, at least the EBay listing !says! that it comes from California - wink, wink.