About
All feedback (88)
- awesomebooksusa (440624)- Feedback left by buyer.Past yearVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- qilv01 (426)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- lli1zcdkruw@Deleted- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (4)
Nov 26, 2016
Stratocaster Conversion Plate
Excellent plate, pick guard cover for converting a Fender Strat or Strat Copy to humbucking pickups.
I highly recommend using Seymour Duncan pickups or other 4-wire humbuckers and installing a 6 pole, on-on-on mini toggle switch between each pot. Then wire the 4 wire pickups like map from Seymour Duncan site to get series, humbucker or single coil. Also, you will get so much tone variation from this setup that you can do completely away with the tone controls. Use 500 ohm CTS pots if you don't already have them and make all three pots volume running the pickups to the on-on-on first then to the volume pots, then to the 5-way switch and then to the output jack.
NOTE* if you have a shield like Seymour Duncan's have, run the shield directly to the volume pot. DO NOT connect it to the pickup wire that shows ground in the drawings.
May 31, 2016
Jack socket
Love the plate, easy to install although no instructions. Jack in inferior to Switch-craft, you might want to change it out but plate is still a good value.
May 04, 2016
Telecaster control plate
Even though the price is very fair, you should plan on sanding, painting and spraying some type of very hard clear coat after the paint cures. The paint that comes on the unit scratches very easily and no matter how careful you are with it, scratches will appear easily.
However, when you consider the cost the price is still fair for a pre-punched metal panel with the holes & slots already drilled.