davidmdavis77 on eBay

About

Location: United StatesMember since: Mar 20, 2011

Feedback ratings

Last 12 months

Positive4- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (168)

laboratoryconsumableexpert (29979)- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.
bigjimstuddaddy (911)- Feedback left by buyer.
Past 6 months
Verified purchase
Thanks...A+
hatch4045 (44869)- Feedback left by buyer.
Past 6 months
Verified purchase
*´•*´¯`*•.¸ .. $ .. ¸.•*´¯`*• Great Thanks! •*´¯`*•.¸ .. $ .. ¸.•*´¯`*•$•*´*•$•*
thedukesawparts (46737)- Feedback left by buyer.
Past 6 months
Verified purchase
THANK YOU SO MUCH, YOU'RE AWESOME -THEDUKESAWPARTS
lrhall38 (75)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
*****- Feedback left by buyer.
More than a year ago
Verified purchase
Fast payment. Wish to do business again! A+++

See all feedback

Reviews (4)

Stihl 1110 353 1600: Fuel tank vent valve, new

May 25, 2025

Perfect fit...

Perfect fit

PLASMA CUTTER 26 CONS PILOT ARC IGBT 50AMP SIMADRE 110/220V 1/2" CLEAN CUT 50DPi

May 20, 2019

Great Value and Good Performance - Couple Issues

This plasma cutter works well and will definitely clean cut 3/8 plate. I assume it will also clean cut 1/2" based on the settings I used to cut the 3/8 plate and it will probably sever 5/8 but 3/4 is probably not possible. The directions are pretty much garbage. Better plan on fumbling through setup and usage although once you get going you will be fine. The air regulator is hard to get to stop leaking. It took me about an hour of tape and pipe dope and manipulation to get the fittings and the plastic line to stop leaking but eventually I did. I look forward to using this for quite a lot of small projects. I would have given it a 5 if the directions were better and the air regulator wasn't such a pain.

2 of 2 found this helpful

LINVILLE Heavy duty 36" backhoe thumb wide model hoe clamp attachment

Mar 08, 2016

High Quality at a Low Price

I purchased this thumb for my John Deere 70D 8 ton excavator. It is of high quality construction and was attached correctly with just 30 minutes of grinding and welding. Appears to be able to take a good amount of stress with no signs of fatigue. I will be using this to move logs medium sized rocks and lots of brush and debris. I highly recommend this thumb for a similar application as mine.

See all reviews