dark_peak on eBay

About

Location: United KingdomMember since: Apr 24, 2006

Feedback ratings

Last 12 months

Positive4- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (50)

*****- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.
sisiuk (374705)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Feedback left by buyer.
Past year
Verified purchase
5* buyer! Thank you for using the All Car Parts store!
jasttan1 (482)- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.
in.studio (138799)- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.
elin.ou (16525)- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.

See all feedback

Reviews (2)

Timeguard ZV900 Automatic Switch Load Controller - NEW

Aug 29, 2018

Yes, it does do the job, but...

This gizmo makes it possible to run LED (or other low-energy bulbs) from a Timeguard timer switch. It is reasonably easy to fit, though it might be a little tricky to fit through the ceiling hole in some cases. Without the ZV900, it was necessary to put some incandescent bulbs in the fitting to provide enough current to work the timer switch. If all of the bulbs were LEDs then they would glow brightly and flicker constantly when they were supposed to be off. With the ZV900, the LEDs do what you would expect - off when they should be off and on when they should be on. BUT... occasionally, the lights will flash briefly. This usually happens when another light in the house is switched on or off, but sometimes it happens for no apparent reason. That is a small problem compared to the savings from now being able to use 100% LED bulbs with the timer, but it is just a little bit irksome.

CK Armourslice Precise SWA Armoured Cable Wire Stripper 12mm to 36mm T2250

Sep 21, 2018

Great tool for SWA cabling.

This is a hefty, well-built tool that - if the instructions are followed - really does make SWA stripping quick and easy. As a first timer with armoured cable, I tried a couple of times with offcuts of cable, and after getting the feel for it was able to make clean, even cuts every time. The first blade is still good after more than 20 uses. Hints: As above - read the instructions! Don't over-tighten the clamp and make sure you rotate in the correct direction.

See all reviews