crys_guth on eBay

About

Location: United StatesMember since: Feb 23, 2015

Feedback ratings

Last 12 months

Positive16- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (315)

wellcover (3707)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
*****- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again. Thank you.
greatandbest (132059)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
hellophone_case (80852)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
gerberknife604 (15031)- Feedback left by buyer.
Past 6 months
Verified purchase
★¸.•*´¯`★★¸.•*´¯`★THANK YOU 5 STAR BUYER★¸.•*´¯★★¸.•*´¯★
isstop (21559)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent buyer. Fast Payment ! A+++++! Thank you!

See all feedback

Reviews (2)

for CONSEW 339RB INDUSTRIAL SEWING MACHINE 3 SPOOL THREAD STAND #D3

Dec 20, 2015

Unsatisfactory for Thread Tree

Just got it in today ( 12-20-15 ) and set it up on new double needle . Looks good in picture like any 3-spool factory thread tree , but it Not and is made of much thinner gauge metal they used on the Thread Spool holding Arm . It's NOT suitable for any industrial sew table . Support Pole is fine, but you put the normal working weight of 3 spools on the arm and they are waving back & forth non-Stop like bobble-heads . .

Consew CSM3000 Sewing Machine Electric Servo Motor, 110 Volt, 1HP, 750W

Mar 22, 2019

Strong Servo Drive, bad Consew service .

It is a strong servo drive . and has good low-end power on slow RPM . I put it on my heavy 135x17 needle Consew straight-zigzag machine . Only complaint is the drive sensor that is connected to the treadle-pedal . every time you turn on power . When treadle pedal pressed, it just takes-off and sews by itself and you have to kick it hard to get it to stop . Not my 1st servo and I sew for 25+ years and run 8 stations with machines in my small shop, and I have made all adjustments to the sensor lever that is possible . I called Consew service for help, and all they suggested for me, was to record and send video of the malfunctions for a tech. to review . Was Not much help for me and I not in business to make videos , so I just went back and went to work. When the drive sensor is totally out I will not buy a Consew servo drive again .

3 of 3 found this helpful

See all reviews