couplebuells on eBay

About

parts for two's and pews

Location: United StatesMember since: Apr 16, 2012

Feedback ratings

Last 12 months

Positive38- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (315)

mrcpartsplus (8299)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
dollarhobbyz_2 (292106)- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again! Thank you!
actioninterestsrc (12543)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
ocoroet (1314)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
horizonhobby (231583)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
mr-retro (335047)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (8)

Remington 1100 1187 Magazine Spring fits 12 gauge - Part #F93188 NEW Made in USA

Aug 18, 2023

Went in as needed, but not the same length as OEM

It was shorter than the oem spring, but it also has a higher spring rate. Only got to check feed and fununction by cycling the action by hand, not firing the 1100. But again, note it is shorter and stiffer than the original.

ARRMA ARA550112 dBoots Fortress MT Tire Set 12mm Hex 1/18 GRANITE GROM HH

Jan 27, 2025

Granite grom back in action. Good oem pa...

Granite grom back in action. Good oem parts for the truck.

Ruger 90720 57 Optic Adapter Plate Black Burris/Vortex Fits Ruger 57

Dec 17, 2021

Direct fit, no issues. Although it's aluminum.

Fit fine, finish and quality is typical ruger. Only complaint is that the adapter is aluminum. That being said, do not go full on with the hardware, you WILL strip it. The fastener does have thread locking compound applied already. So just go to about 16 or 18in lb of torque. I don't have a wrench that goes that low. So i went snug, then another 1/4 turn. Mine may work lose over time. If so I'll take them out, and use red loctite and apply the same low torque. Better to do a job twice, than to have to buy any part twice. Side note, the factory vortex optic cover does not clear the rear sight with this base. It still goes over top of the red dot, but is not seated all the way. So it can come off very easily.

See all reviews