cmills72907 on eBay

About

Location: United StatesMember since: Oct 25, 2013

Feedback ratings

Last 12 months

Positive8- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (225)

the_golfworks (83447)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
e***3 (381)- Feedback left by buyer.
More than a year ago
Verified purchase
Thanks so much. That was the fastest shipping ever.
nunu55_12 (582)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
3capybara (295)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
inoxia_ltd (32299)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
uwholesalersdeals (48668)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (5)

VOLQUARTSEN Bolt Recoil Buffer Ruger 10-22 LR , Magnum & Charger

May 30, 2018

Hard to install

In order to install this product, you have to remove the original OEM stainless steel pin, then you have to install this product in its place. This product is like a small section of a hot glue stick, only stronger. With some effort, because of very tight tolerances, you can hammer it through one hole. The problem is hammering it through the second hole. This product tends to bend rather than make it through the second hole. No instructions came with the product to advise customers how to accomplish this feat. I used the original OEM pin and a hammer to force this product into place...and it’s still not all of the way through the second hole. In looking at the competing products, in hindsight, I think I would have made a better choice to purchase the buffer with a stainless steel inner core and an exterior which is of a softer material (for the recoil buffer characteristic). The competing products would be easier to install, at least to the extent that they would not bend. However, I would imagine that the softer material in those competing products would tend to squish rather than make it through the second hole. The “perfect” product would be a stainless steel pin, like the factory OEM pin, with the outer diameter shaved down 3/16 of an inch, only in the middle area inside of the receiver, excluding the length of the pin on both sides of the pin, which is necessary to fit snugly within the holes of the receiver. Lets just say the depth of the hole in the receiver is a 1/4 inch. That means the pin has an OD on each end that is 1/4 inch long, then the OD reduces by 3/16 of an inch. Why? To allow for a softer material to take its place. This would allow easy installation while also serving the intended purpose of this product: to reduce recoil.

1 of 7 found this helpful

Russell 670600 Aluminum Tank Welding Bung #10 7/8" - 14 SAE

May 18, 2024

I got what I ordered. It is perfect for my use.

Logitech M100 Mouse - Corded USB Mouse

May 17, 2024

This corded USB mouse works. It was shipped fast and is affordable. I needed it because I need to repair Windows and Windows was not letting my wire

This corded USB mouse works. It was shipped fast and is affordable. I needed it because I need to repair Windows and Windows was not letting my wireless mouse work.

See all reviews