About
All feedback (139)
- suthaklin3 (38)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- linskef (1481)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy & pleasant transaction. Excellent buyer. A++++++
- allseasonspartsinc (121031)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- richlandcreekholdingsllc (5749)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- hondaacs (40782)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (37)
Nov 30, 2024
Carbureator rebuild kit
Products gaskets fit well. There were two different big gaskets; I used them one on top of the other, because of the tenancy of this carburetor to warp. One part, the one that holds the long needle valve I could not get out because one needs a special tool to do so. But the smaller brass fitting in the kit was threaded, but on the carb was pressed in, and again, one needed a special Briggs tool to extract, so I left it. In the end, I more or less got the carb to no longer leak gasoline through the gaskets, but the engine is still difficult to start, and I can't seem to start it hot. It will start cold, but if it stops, (and it did stop on me the first time I ran it with the carb rebuild kit), I had to wait for the engine to cool to get it going again. Then it ran; I finished my project, which was chipping a pile of shrub brush. So again, it does not seem to leak now, probably because I doubled the gaskets which entailed trimming the holes of the second gasket to correspond to the first, and really tightened the carb halves together. Engine runs cold, and can run a long time. But I can't get it to start when hot.
Oct 31, 2024
small room three speed fan
Fan is what is was said to be. It has two colors of fan blades, and pull chains for the light and fan speeds. I hooked it up to a three speed switch, which was separate from the light. Arrived on time and in good condition.
Is it a good value? Kind of expensive. I paid about $120 for it; it was $140 in the store, but in a store called Menards in Wisconsin, the same fan was $95.
May 14, 2020
godd product for the money
Product was good value; cost less than Brigss marked product, but is the same size and fits fine.
No leaks.