About
All feedback (1,817)
- biycileke (8761)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- lucky-son96 (3114)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- madimasu (310)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- weopcvbnf902 (489)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- zuiti78 (3299)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- focal-au (52825)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (4)
Oct 18, 2015
Retro, Challenging, and very enjoyable
System shock 1 , While older has great atmosphere similar to the original doom but with voice acting , You may need to Install the mouse look mod (also to get standard Wasd controls) and run it through Dosbox . But it is worth it. Oh .. and just a tip "E" enables and disables the Look mod , and you need to Jump and move forward to climb the Ladders. Install the mod and have fun .. I sure did.
Mouse look mod info
- Setup guide : Search "System Shock (PC) FREE (Setup Guide)" Its on You tube
Jul 21, 2020
One month Heavy Use and the #YMH28950 is still a Quality Belt at a Great Price. *Attached Photos are after one month of use
The YMH28950 belts (In my case for My Bissel AeroSwift Compact 1808c Belt Bissell #1600319/#YMH28950) was an exact fit, and the Rubber has a very nice feel of quality to it.
A Philips screwdriver to remove the bottom panel, as well as a flat head screwdriver to coax the belt in and around the Motors Drive shaft were all that were required during the painless install.
I have been using the belt heavily for about a month now and it has not emitted any Odors that some belts do during their brake in periods.
I have to say feeling the power of the beater brush vibrate through the floor again is most satisfying . So if you have a little DIY in you , I would Recommend this project.
Jan 09, 2020
Works well, but Through hole as surface mount pulls off board, and requires quick fix
I currently have 10 of these, and although the 3.5mm through hole jacks have their leads bent so they could be soldered as surface mount, resulting in a few pulling off the board, it is an easy fix to rebend the leads and resolder them as through hole. No issue with the function of this device, the audio is quite clean.