albart57 on eBay

About

Location: CanadaMember since: Jun 26, 2007

Feedback ratings

Last 12 months

Positive1- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (110)

czb6721960 (314631)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
xcailau (35249)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
ce10wy (52710)- Feedback left by buyer.
More than a year ago
Verified purchase
Good Buyer. Patient and gentlemen. Fast payment .A
elecbuy (23451)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
*****- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
sobedigital (28449)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (3)

HK0810 Miniature Needle Roller Bearing (8mm*12mm*10mm)

Sep 30, 2020

As described. Satisfied with this product.

I used this to support an 8 mm z-axis lead screw for a 3D printer. This is not a demanding application so I think it will work very well. It fits easily over the lead screw. The outside diameter is exactly 12 mm measured on a digital caliper. The length is 9.9mm also measured on a digital caliper. The rollers move smoothly.

3pcs M5 x 45 mm (0.5mm Pitch) Fine Thread Allen Hex Bolt Socket Head Cap Screw

Oct 30, 2020

Significantly undersized, very loose fit.

Thread major diameters were between 4.6 and 4.7 but should have been in a range of 4.874 to 4.984 so they were very loose fit. Other than that the head was well formed and there were no obvious defects.

Replace Power Supply for Shuttle XPC S093G Promise NS4300n NS4600n

Nov 08, 2017

Works for NS4300N with modifications

I bought this to replace the power supply for a Promise NS4300N as noted in the product description. This supply has unnecessary extra cables for floppy and eSATA (as noted in the description) so I ended up cutting those off to fit easily in the case. I also compared the 24 pin connector with the original connector and cut any lines that were not on the original, except for the extra +5V red power lines. e.g. -12 volt blue. The power supply fit perfectly into the Promise case and has powered it without problems. Other replacement supplies without the extra power cables cost two to three times as much so good value.

See all reviews