About
All feedback (1,517)
- sb71-25 (951)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for a great transaction,pleasure doing business with you
- thebatterypowerhouse (2750)- Feedback left by buyer.Past 6 monthsVerified purchaseThank You!!
- dcpowerbeiter (3818)- Feedback left by buyer.Past yearVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- reese04020 (5552)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- messhall* (2208)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- driftingtreasures (1694)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (4)

Apr 25, 2016
Surprise quality
I LIKE a full-size USB keyboard that plugs in - no "air-wires" for this retro system administrator. Surprised by the quality and (key) touch of this model. Tried a few others, tossed the rest. It has even managed to survive one coffee spill :)

Apr 25, 2016
Fits a niche - economical, works
I bought this for a two-part single purpose: Mixing and applying epoxy
Mixing epoxy glue. I needed transparent, so I could easily measure portions (used a marking pen and a ruler from the outside) and then pouring hardener and resin to the appropriate lines
Applying: nipped off the spout with a razor to get the right size hole and squeezed it in.
Good - keep my fingers out of some very nasty stuff. Inexpensive, this has a one-time destructive use for my needs.
Bad - for some people - the attached cap does not stay "fastened" on any of the five I purchased. If that is a feature you need, then you want another product.
Good - depending - smallish diameter container. Didn't measure, but guessing 1.25 - 1.5 inches. Smaller than others, but excellent for my measuring purposes. It saved expensive epoxy.
Enjoy

Apr 25, 2016
Freud - always the best choice
Freud is always the go-to brand for particular woodworkers. Cuts all woods like butter, stays sharp, no chatter or vibration, safe.
I needed the end bearing flavor to finish a template routing of a 7-foot long 3" thick piece of Cherry - JUST made the thickness with this and another Freud bit. The discrepancy between bits was "seeable," but I not measurable. Less than .005" I am guessing. A little sanding and I was done.