a6domis3 on eBay

About

Location: United StatesMember since: Jul 05, 2015

Feedback ratings

Last 12 months

Positive33- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (317)

envistia (43577)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with. Thank you!
motorcycleinsight (2263)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect, thanks for the easy transaction!
simplecellllc (338814)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
heroshop (586)- Feedback left by buyer.
Past 6 months
Verified purchase
Pleasure doing business! Thank you for your purchase, highly recommended buyer!
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

See all feedback

Reviews (3)

6 PC. VALVE TAPPET ADJUSTING TOOL FOR HONDA YAMAHA SUZUKI KAWASAKI MOTORCYCLES

Sep 27, 2019

Good tools! Do not use for Honda VF500 engine though..

I got these to try to adjust the valve tappets on my v30 Magna. I used the 8mm/3mm square bits. Good quality tool, and its a good idea, but it just doesn't work in the vf500 engine. There just isn't enough space. I still used the 3mm square bit but it was still tight! Again, great tools, I just wouldn't recommend it if you plan on using it on a vf500 engine magna/interceptor.

JB Weld High-Heat Epoxy Stick

Sep 27, 2019

Easier than welding. Takes the heat!

I used this to stick a broken weld joint on a heat shield on my exhaust. I used this right up near the exhaust headers where it gets really hot, and its been holding up wonderfully. No more brain-shaking rattling! Easier than actual welding!

1 of 1 found this helpful

Honda Carb Carburetor Float and Pin x2 CB400T CB900F CX500 CM250 CM450A FT500

Sep 27, 2019

Just like OEM, but cheaper!

Initially I was worried that since this wasn't an OEM float that the float height wouldn't be right, that was not the case at all. I needed to replace an original float that wasn't adjustable so I got these. Using the original needle valves these floats sit at the right height. And they're much cheaper than OEM. I know a lot of people are worried about aftermarket products in this category but these are A-OK!

See all reviews