About
All feedback (252)
- cgdirect2u (515)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat Buyer! THANK YOU SO MUCH!
- slayn_n_korpil (1428)- Feedback left by buyer.Past yearVerified purchaseGreat communication. A pleasure to do business with.
- *****- Feedback left by buyer.Past yearVerified purchaseGreat communication. A pleasure to do business with.
- xyz-electronics (4146)- Feedback left by buyer.Past yearVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- *****- Feedback left by buyer.Past yearVerified purchaseI wish there were more like this buyer!!! A++ Thanks again!!
- unitskysky (3795)- Feedback left by buyer.Past yearVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (12)

Mar 07, 2017
4/5 Sub C
Perfect for a rebuild of my Black and Decker VersaPak. Cells have correct dimensions and long tabs. Cells were shipped with heat-shrink on the tabs and then each individual cell is shrink wrapped.

Feb 13, 2018
Waste of money
1 of 1 found this helpful Very poor accuracy on current.
I purchased two. With both units connected in series both show 0.00 A. The current required to drive the displays is not indicated!
When connected in series with a resistive load and a two other current meters the units read low. E.g.:
Actual current 0.73 A, indicated current 0.67 / 0.67 A
Actual current 0.41 A, indicated current 0.32 / 0.35 A
Actual current .175 A, indicated current 0.08 / 0.11 A
The accuracy of the voltage reading is better but not good. E.g. With actual voltage 5.22 indicated voltage 5.28 / 5.29.
I opened one unit and the quality is horrible. There were stray solder lumps stuck to the board near areas of hand work. The display units were not seated properly on the board.
The vendor did not reply to my question about accuracy.
Don't waste your money!

Sep 21, 2022
Tested at 1 amp
1 of 1 found this helpful 2 modules were used to develop and test a prototype aircraft recognition light flasher. They performed intended function.
Not tested to advertised maximum current but they had no problem switching 1 amp.
Only 2 of the 10 pieces have been used or tested.