About
Reviews (2)
Oct 03, 2016
Misleading
0 of 1 found this helpful After ordering these filters (2) I discovered that these have zero water separating properties, but because it has a drain valve, it has been labeled a f/w separator by Fleetgaurd. Keep this in mind when ordering and also keep in mind that it only takes a few tablespoons of water to blow the tips of your injectors off into your cylinder, thus having the potential of damaging your engine to the point of needing a rebuild!
May 30, 2017
Interference issues
Anyone who owns a jeep with the 4.0 knows the header nightmare. Engine runs lean and cracks out the manifold. I've spent probably a couple thousand on exhaust manifolds for mine, with the same result, so this time I figured cheap was best, why spend 500 on something that's just gonna last 6 months to a year before it craps out? While this header bolts up, it's far from a direct replacement. I had to cut the webbing from in between the intake ports and dent #6 tube to clear the intake manifold. The exhaust tubes extended too far before sloping downward. The mounting flange is also thicker than the intake causing the cup washers to only apply minimal pressure to the intake and the face of the exhaust mounting flange is not machined after being tig welded, this would remove any warping caused by heat. Only time will tell on the longevity of this manifold?